SMOG-EATER - Electrostatic Precipitator
In some factories where air pollution is created, it is not possible
for a variety of reasons to collect the pollution at source. In such
circumstances a good alternative is to install equipment at high level
to provide a general clean-up of the workshop atmosphere. Our range
of SMOG-EATER models illustrated on this page are self contained industrial
electrostatic air filters. They are equipped with an integral sump and
drain outlet, making them suitable for both dry and liquid contaminant
collection. The collecting cells are manufactured from aluminium and
therefore require periodic cleaning only, not replacement i.e. no on-going
filter replacement costs.
The SE.22 is ideal for the average sized
factory, the SE.11 for the smaller factory, particularly large areas are best
served by the larger models SE.44 and SE.44.SS.
The units are ideally suitable
for the cleaning of welding fume, oil mist/oil smoke, brazing fume, PVC fume,
rubber smoke and general air borne contaminants. All units are fitted with support
bars top and bottom for easy connection to roof steelwork, alternatively they
can be wall mounted or bracketed at high level on vertical stanchions. Each unit
is provided with an indicating light to show when cleaning is required.
of units required? Contact Horizon and we will be pleased to survey, and/or advise
following receipt of the workshop dimensions, i.e. width, height, length, detail
of production within, obstructions e.g. overhead cranes etc.
Siting of the air cleaning units relative to each other is important
to ensure an even distribution of cleaned air.
|Nominal Air Volume
||1070 x 500 x 480mm H
||1070 x 915 x 480mm H
||1450 x 970 x 1010mm H
||2300 x 1030 x 690mm H