SMOG-EATER - Air Cleaning Filters
In some factories where air pollution is created, it is not possible
for a variety of reasons to collect the pollution at source. In such
circumstances a good alternative is to install equipment at high level
to provide a general clean-up of the workshop atmosphere. The models
illustrated on this page are self contained industrial air filters.
The internal mechanical air filters are selected to match the type of
dust to be collected.
The SE.22HPM is ideal for the average sized factory, the SE.11HPM for
the smaller factory, particularly large areas are best served by the
larger models SE.44M and SE.44.SSM.
The units are ideally suitable for the cleaning of general air borne
contaminants e.g. fibreglass dust, linen dust, grinding dust e.t.c.
All units are fitted with support bars top and bottom for easy connection
to roof steelwork, alternatively they can be wall mounted or bracketed
at high level on vertical stanchions.
Number of units required? Contact Horizon and we will be pleased to
survey, and/or advise following receipt of the workshop dimensions,
i.e. width, height, length, detail of production within, obstructions
e.g. overhead cranes etc.
Siting of the air cleaning units relative to each other is important
to ensure an even distribution of cleaned air.
|Nominal Air Volume
||1070 x 500 x 480mm H
||1070 x 915 x 480mm H
||1450 x 970 x 1010mm H
||2300 x 1030 x 690mm H