 |
The HEAT-RAD™ industrial
heating system is suitable for both full heating and also localised/spot
heating.
Localised/Spot Heating
Higher radiant intensities are required where partial/spot heating
is to be employed. To be fully effective, the installation height
should be the minimum figure stated below for full heating systems,
less 0.4m. Preferably use more than one heater giving radiation
from at least two directions.
|
|
Full Heating
The table below gives an approximate sizing guide, however this
is intended as a quick guide reference only and should not replace
the facility offered by Horizon i.e. a full design heat loss calculation
to determine the most economic combination of units/size required.
|
| HEAT-RAD™
Industrial Heating - Approximate Sizing Guide |
| Model |
Rating |
Area Served |
| HR.45/HR.45.FD |
13Kw(45,000 Btus/hr) |
37 - 65 Sq.m (400- 700 Sq.ft)when mounted at
3.0 - 4.5m (10'0" - 14'6") |
| HR.75/HR.75.FD |
22Kw(75,000 Btus/hr) |
70 - 102 Sq.m (700 - 1100 Sq.ft)when mounted
at 3.6m - 6.0m (12'0" - 19'6") |
| HR.130/HR.130.FD |
38Kw(130,000 Btus/hr) |
102 - 186 Sq.m (1100 - 2000 Sq.ft)when mounted
at 4.25m - 15.0m (14'0" - 50'0") |
|
|
Gas Supply
HEAT-RAD industrial heating equipment is suitable for all types
of gas e.g. Natural Gas, Propane, LPG and are easily converted from
one gas to another.
Installation
Buy Heat-Rad equipment direct from the manufacturer for installation
by local CORGI registered fitters, alternatively ask Horizon for
a quotation for a fully installed industrial heating system.
|
